Interior putty KOVA DXis a putty designed to smooth indoor walls to cover imperfections before painting, has been fully tropicalized, suitable for most types of construction.
SUPERIOR CHARACTERISTICS
Smooth surface.
Easy sanding.
Easy to construct.
No crow's feet cracking.
No blistering.
High strength, good weather resistance.
Tightly bonded with the capillaries of concrete and cement mortar for good adhesion.
PRODUCT INFORMATION
Pack:Bag 40kgApplicable surface: Cement mortar, concrete, brick, plaster ceiling.Dry Thickness: About 1mm per layer. The optimum thickness for 2 coats after drying is about 1.5 mm. Do not apply too thick powder because it will reduce the durability of the entire coating system Theoretical norm: 35 – 40 m²/bag (for 2 layers), depending on the material surfaceDilution: Add 16-20 liters of clean water for each 40kg bag
CONSTRUCTION INSTRUCTIONS
SURFACE PREPARATION
New wall : Must be allowed to dry and stabilize the structure (minimum 12-15 days). Clean dirt.
Old walls : Must remove grease, moss, old layers of paint, lime, then rinse thoroughly with clean water and let dry.
CONSTRUCTION
Step 1:Mix putty and clean water in the ratio of about 16-20 liters of clean water/bag. Add the putty slowly into clean water and stir thoroughly until the consistency is medium (a mixer is recommended). Let stand for 5 minutes, then stir again until homogeneous. Depending on the weather, if it is too thick, you can add a little water to make it easier to spread.
Step 2:Use two layers of trowel, spaced 3-4 hours apart. Leave to dry after 6-8 hours, use sandpaper to flush flat, blow away dust, can apply primer.
NOTE
The water used to make putty is absolutely clean water. Do not use dirty or contaminated water.
If the wall has cracks, it must be filled with elastic waterproofing CT-14 first.
If the weather is too dry, it is necessary to moisten the wall before applying putty.
Plaster should not be applied too thickly because it will reduce the durability of the entire coating system.
Use wherever, mix there. Should be applied within 60 minutes to avoid setting.
Do not add other powders to KOVA putty.
Clean tools with clean water immediately after use.
SAFETY, HEALTH AND ENVIRONMENTAL INFORMATION
The working environment must be well ventilated. Wear gloves, masks and eye protection while working. In case of eye contact, wash with plenty of clean water and consult a doctor immediately. Please refer to the latest technical and safety documentation before use
Đại lý có tài khoản vui lòng đăng nhập để mua hàng hoặc đăng ký tài khoản (tại đây).
Nếu bạn chưa là đại lý trong hệ thống Cường Lâm vui lòng liên hệ chúng tôi (tại đây).
